ZhanSong Industrial Co. LTD


Precautions after processing CNC Turning Machine

Author:admin Date:10/10/2018 9:34:15 AM
Note on the completion of CNC lathe processing:
1. Remove chips, wipe the machine, and keep the machine and environment clean.
2. Pay attention to check or replace the oil wiper on the machine tool rail damaged by the mill.
3. Check the status of lubricating oil and coolant and add or replace them in time.
4. Turn off the power and main power on the machine's operation panel in turn.
5. When the machine is turned on, it should follow the principle of zero return (except special requirements), manual, jog and automatic. The operation of the machine tool should follow the principle of low speed, medium speed and high speed first, and the running time of low speed and medium speed should not be less than 2-3 minutes. You can start working when you are sure that there are no abnormalities.
6. It is strictly forbidden to knock, correct and correct the workpiece on the chuck and the tip of the ding. Bi must confirm that the workpiece and the tool are clamped before proceeding to the next step.
7. The operator must stop when he changes tools, workpieces, adjusts the workpiece or leaves the machine while working.
8. The insurance and an full protection device on the CNC CNC lathe shall not be disassembled and moved by the operator.
9. Before the CNC lathe starts processing, the bi-test must be checked by the program to check whether the used program is similar to the part being processed. After the confirmation is correct, the full protective cover can be managed and the machine can be used for part processing.
10, machine tool accessories and measuring tools, tools should be properly kept, to maintain complete and good, lost or damaged parry compensation.
11. After the training is completed, the machine should be cleaned, kept clean, the tailstock and the carriage are moved to the end of the bed, and the machine power is cut off.

online service